As a result of the digitalization of the power business in Norway and Europa, a lot of new possibilities and challenges arise. In 2014 an expert committee one outlined a proposal for the future grid company structure in Norway (Reiten, 2014). In addition, new technologies are being implemented in the system. Wind power, solar power, un-regulated small hydro power production, battery storage domestic ...

The study of the network design problems related to reverse supply chain and reverse logistics is of great interest for both academicians and practitioners due to its important role for a sustainable society. However, reverse logistics network design is a complex decision-making problem that involves several interactive factors and faces many uncertainties. Thus, in order to improve the reverse ...

In this paper dual-quaternions are used to model a fully actuated rigid-body. A backstepping-controller that solves the trajectory tracking problem is derived and proved to provide uniform asymptotical stabilization of the error dynamics. Numerical simulations are provided where the controller is compared to existing dual-quaternion tracking controllers and it is shown to have similar performance.

This paper proposes a new path-planning algorithm based on GERBS to generate curvature continuous paths. The algorithm blends between a set of local curves generating a global smooth path which also interpolates the midpoint of the curves. Numerical examples are provided which demonstrates the potential of the proposed algorithm.

Collaborative Robots provide many possibilities, when it comes to Human-Robot Collaboration. Until now, these approaches are usually custom made, sensor-integrated solutions, where the robot's safety controller ensures the safety of the human worker. These solutions are according to today's rules and standards. We propose to extend these solutions with including Virtual Realty as a sensor and to ...

This paper describes a framework for simulating household appliances in Simulink. Typical Norwegian household equipment have been analyzed based on their characteristic behavior, to establish the requirement for synthesizing and recreating their current waveform, harmonic currents and phase shift. Both detailed simulation of the current waveform and RMS currents for simulation over longer time periods ...

This paper presents a control strategy for grid connected voltage source converters with LCL filter, based on a cascade of two model predictive controllers (MPC). Despite the attention MPC has received in the research community over the last years, there are still raised question about what advantages such control methods can offer, compared to existing established control strategies. The cascaded ...

This paper presents several different control structures that facilitate flight control and does a comparison between them. Specifically, this paper considers command-filtered backstepping, nonlinear dynamic inversion (NDI), and a new decoupled approach that decouples the rotational and translational dynamics by estimating the higher order derivatives of the angle of attack and sideslip angle. The ...

Since 2013, the postal service provider in Norway: Posten has implemented a new strategic plan to close their large post offices across the country for improving the cost and operational efficiency. Instead, with the cooperation with large retailers, the local postal service is provided at the Posten sub-branches at some supermarkets. In this paper, an optimization problem for relocating the post ...

This paper presents a three dimensional guidance strategy for fixed-wing UAVs using quaternions. The algorithm is based on constructing two quaternions, one which makes the UAV fly towards the path and one that makes the UAV follow the path. These two quaternions are then blended together such that the path-following objective is reached. The guidance algorithm is applied to a simple kinematic model ...