ub.xmlui.mirage2.page-structure.muninLogoub.xmlui.mirage2.page-structure.openResearchArchiveLogo
    • EnglishEnglish
    • norsknorsk
  • Velg spraaknorsk 
    • EnglishEnglish
    • norsknorsk
  • Administrasjon/UB
Vis innførsel 
  •   Hjem
  • Fakultet for ingeniørvitenskap og teknologi
  • Institutt for automasjon og prosessteknologi
  • Artikler, rapporter og annet (automasjon og prosessteknologi)
  • Vis innførsel
  •   Hjem
  • Fakultet for ingeniørvitenskap og teknologi
  • Institutt for automasjon og prosessteknologi
  • Artikler, rapporter og annet (automasjon og prosessteknologi)
  • Vis innførsel
JavaScript is disabled for your browser. Some features of this site may not work without it.

Multiphysics Analysis of Ice-Polyurethane Adhesion under Flexural Loading using FEM Analysis

Permanent lenke
https://hdl.handle.net/10037/23765
DOI
https://doi.org/10.21152/1750-9548.15.4.437
Thumbnail
Åpne
article.pdf (478.3Kb)
Publisert versjon (PDF)
Dato
2021-12-26
Type
Journal article
Tidsskriftartikkel
Peer reviewed

Forfatter
Eidesen, Hans-Kristian; Andleeb, Zahra; Khawaja, Hassan; Moatamedi, Mojtaba
Sammendrag
This paper presents the Finite Element Analysis (FEA) Multiphysics technique, applied to study the strength of ice adhesion between the surface of polyurethane and ice. The theoretical study of this work is based on the Euler-Bernoulli beam theory that is used to solve a four-point bending problem to give the correlation of displacements with load and longitudinal stresses. The physical samples were prepared by freezing ice over the polyurethane surface and were tested experimentally in a four-point flexural setup. In the experiment, masses were added to the four-point bench until the ice separated from the surface. The results revealed that the ice adhesion on the surface of polyurethane is in the same range as with other polymers. The displacement at the time of separation was recorded, and the same conditions were used to perform numerical simulations in ANSYS® Workbench. The meshed ice-Polyurethane Finite Element Method (FEM) model was tested for sensitivity. A good agreement was found between theoretical, experimental, and numerical simulation results.
Forlag
International Society of Multiphysics
Sitering
Eidesen H, Andleeb Z, Khawaja HA, Moatamedi M. Multiphysics Analysis of Ice-Polyurethane Adhesion under Flexural Loading using FEM Analysis. The International Journal of Multiphysics. 2021;15(4):437-452
Metadata
Vis full innførsel
Samlinger
  • Artikler, rapporter og annet (automasjon og prosessteknologi) [172]
Copyright 2021 The Author(s)

Bla

Bla i hele MuninEnheter og samlingerForfatterlisteTittelDatoBla i denne samlingenForfatterlisteTittelDato
Logg inn

Statistikk

Antall visninger
UiT

Munin bygger på DSpace

UiT Norges Arktiske Universitet
Universitetsbiblioteket
uit.no/ub - munin@ub.uit.no

Tilgjengelighetserklæring