Show simple item record

dc.contributor.advisorBuenz, Stefan
dc.contributor.advisorPlaza Faverola, Andreia
dc.contributor.authorLium-Wickler, Adrian
dc.description.abstractThis thesis analyzed P-Cable high-resolution 3D seismic data from the Bear Island Fault Complex in the southwestern Barents Sea acquired during a Helmer Hanssen cruise in 2012. Hence, the thesis is divided into two parts: the first part of the thesis focuses on the steps taken during the processing of the raw seismic data from the Lundin 2012 Area-A survey located at the Bear Island Trough Fault Complex. The processing includes assigning geometry to the seismic data, correcting the source-receiver offset, and then assembling a cube from the seismic lines through CDP Binning. After creating the 3D cube, the signal to noise ratio is improved through filtering procedures. For this project, the Ormsby filtering was used to remove noise from the seismic signal. Ghost signals were removed trough a DeGhosting process. Import of tidal data was done to attenuate some of the noise created by variations in water depth. Normal move out and stacking was done before migrating the data. After migration, the data was exported to Petrel for the interpretations. The second part of the thesis focuses on the interpretation of the processed 3D seismic data with emphasis on hydrocarbon indicators, shallow gas accumulations, and potential migration pathways. The stratigraphy of the area was correlated through well 7219/9-1. This was done by tracing stratigraphical boundaries across several 2D lines before connecting with the dataset. Within the dataset, I observe the Top Hekkingen Formation up to the Torsk Formation. The top of the Torsk Formation is cut by the Upper Regional Unconformity (URU), which is overlain by glacigenic sediments. Large-scale normal faults interpreted as half-gradens, with small-scale faults within the blocks, are seen in the eastern part of the dataset. On the seabed, we see features such as iceberg ploughmarks and pockmarks. Pockmarks mainly occur within the ploughmarks and are located above flat spots seen at the URU in seismic cross section. Most of the gas accumulations are observed at the URU with the overlaying Neogene sediments acting as a seal for further gas migration. A flat spot was also observed within the Jurassic sediments. Evidence of fluid migration through faults and permeable layers are seen as areas with acoustic masking. The vertical fluid migration seems to terminate at the observed gas accumulations at the URU. A few examples of gas migration to the seabed are observed through pipes with associated pockmarks. This might be due to overpressure created beneath the URU seal.en_US
dc.publisherUiT Norges arktiske universiteten_US
dc.publisherUiT The Arctic University of Norwayen_US
dc.rights.holderCopyright 2015 The Author(s)
dc.rightsAttribution-NonCommercial-ShareAlike 3.0 Unported (CC BY-NC-SA 3.0)en_US
dc.subjectVDP::Mathematics and natural science: 400::Geosciences: 450::Marine geology: 466en_US
dc.subjectVDP::Matematikk og Naturvitenskap: 400::Geofag: 450::Marin geologi: 466en_US
dc.titleA shallow gas flat spot anomaly in the Bjørnøyrenna Fault Complex in the Barents Sea: processing and interpretation of P-Cable 3D seismic dataen_US
dc.typeMaster thesisen_US

File(s) in this item


This item appears in the following collection(s)

Show simple item record

Attribution-NonCommercial-ShareAlike 3.0 Unported (CC BY-NC-SA 3.0)
Except where otherwise noted, this item's license is described as Attribution-NonCommercial-ShareAlike 3.0 Unported (CC BY-NC-SA 3.0)